The ZeroPinch v10 bipod holder fits your standard 1.25" Seco/Trimble/Leica prism pole.
"How is this different than what I already have on my rod?"
The ZeroPinch v10 accepts the bipod legs at a wider angle, allowing for the bipod legs to run parallel to the prism pole. No more twisting. The wider angle allows for the ZeroPinch to sit much higher on the prism pole, out of harms way.
"Bipod holders are a throw away item, they're useless, what makes yours so special?"
The ZeroPinch v10 is special because it solves a problem we've both dealt with for as long as we've been surveying, crushed fingers. The ZeroPinch v10 cinches on to the prism pole with a hearty 2" of 3/8" thick carbon fiber. Each leg of the bipod is held securely in place by 1" of 3/8" thick carbon fiber. The days of those legs flopping around and crushing your fingers is over. The ZeroPinch is held rigidly on the prism pole by a stainless M4 bolt and stainless wing nut, making installation a breeze.
The holder is machined from PA12 CF, which is a Polyamide 12-based 3D printing filament (PA12, Nylon12), reinforced with carbon fiber. Carbon fiber enhances nylon’s stiffness, strength, rigidity, shrink ratio, and surface quality, as well as improving chemical and thermal resistance. Outstanding stiffness and strength.
